Filaments.ca
PETG 1.75mm
Set your print bed temperature to approximately 65°C (hotter for the first few layers if possible).
If further bed adhesion is requires, keep increasing the bed temp by 5°C until it improves.
PETG doesn’t need to be squeezed onto your heated bed, you want to leave a slightly larger gap on the Z axis to allow more room for the plastic to lay down.
If the extruder nozzle is too close to the bed, or previous layer it will skim and create stringing and build-up around your nozzle.
We recommend starting off moving your nozzle away from the bed in 0.02mm increments, until there is no skimming when printing.
(if the print bed is not heated, consider using brim instead, 5 or more mm wide.
Set your print bed temperature to approximately 60°C (hotter for the first few layers if possible).
If not using a heated bed, try raising your hot-end temperature.
Our PETG filament is characterized by consistent quality, high dimensional accuracy and has been extensively tested on a variety of printers; yielding very strong and precise prints.